Home › Vehicle Interior › HEATING / AIR CONDITIONING › PTC HEATER ASSEMBLY

PTC HEATER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
(Click here)


2. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
(Click here)


3. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)

HINT:
Use the same procedure as for the LH side.



4. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)

HINT:
Use the same procedure as for the LH side.



5. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
(Click here)


6. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)
(Click here)


7. REMOVE SHIFT LEVER SUPPORT
(Click here)


8. REMOVE FLOOR CARPET BRACKET RH


    E227159
  1. Remove the 2 clips.

  1. Disengage the 2 guides to remove the floor carpet bracket RH.



9. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY


    E227191
  1. Disengage the 2 claws and guide, and remove the No. 1 air duct sub-assembly as shown in the illustration.



10. REMOVE QUICK HEATER ASSEMBLY


    E239793
  1. Disconnect the quick heater connector.

  1. Remove the bolt.

  1. Disengage the 4 clamps.



    E234658
  1. Remove the 2 screws.



    E234659
  1. Remove the quick heater assembly as shown in the illustration.