REAR SEAT SIDE AIRBAG ASSEMBLY (for TMMK Made) > INSTALLATION |
| 1. INSTALL REAR SEAT AIRBAG ASSEMBLY |
Install the rear seat airbag assembly to the rear side seatback frame sub-assembly with 2 new nuts.
Engage the clamp to connect the airbag wire harness.
Engage the 8 hooks to install the rear side seatback cover with pad.
| 2. INSTALL REAR SEAT SHOULDER BELT GUIDE |
![]() |
Engage the guide.
Install the rear seat shoulder belt guide LH with the 2 screws.
| 3. INSTALL REAR SIDE SEATBACK ASSEMBLY |
Engage the hook.
Install the rear side seatback assembly LH with the 2 bolts.
Connect the connector.
Connect the rear seat outer belt assembly to the rear seat shoulder belt guide.
| 4. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 5. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.
![]() |
Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.
Confirm that the rear seat cushion assembly is securely installed.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 8. INSPECT SRS WARNING LIGHT |