BLIND SPOT MONITOR SYSTEM > SYSTEM DESCRIPTION |
| GENERAL |
The blind spot monitor system has the blind spot monitor function and RCTA function.
Blind spot monitor function
RCTA function
| FUNCTION OF COMPONENTS |
| Component | Function |
| Blind Spot Monitor Sensor |
|
Outer Rear View Mirror Assembly
| Turns on or blinks the indicator based on a signal from the blind spot monitor sensor. |
Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly)
|
|
| RCTA Buzzer (Blind Spot Monitor Buzzer) | Sounds based on a signal from the blind spot monitor sensor. |
Combination Meter Assembly
|
|
| Main Body ECU (Multiplex Network Body ECU) | Sends the destination information and the dimmer signal to the blind spot monitor sensor via CAN communication. |
Brake Actuator Assembly
| Transmits a vehicle speed signal to the blind spot monitor sensor via CAN communication. |
| ECM | Sends reverse signal and HV flag signal to the blind spot monitor sensor via CAN communication. |
| Steering Sensor | Detects the angle of the steering wheel and sends the resulting signals to the blind spot monitor sensor via CAN communication. |
| OPERATION DESCRIPTION |
Operation description of the blind spot monitor function
Operation conditions
Conditions in which a sensor can detect a vehicle
The blind spot monitor function indicates detection of a vehicle in the detection area when either condition is met:
![]() |
Detection area
Vehicles in the following areas can be detected:
| *a | Vehicles in the following areas can be detected: |
| *b | Within approx. 3.5 m (11.48 ft) from the side of the vehicle |
| *c | Within approx. 3 m (9.84 ft) behind the rear bumper |
| *d | Within approx. 1 m (3.28 ft) forward of the rear bumper |
Operation description of the RCTA function
Operation conditions:
Conditions in which a sensor can detect a vehicle
The RCTA function indicates detection of a vehicle in the detection area when both conditions are met:
![]() |
Detection area
Vehicles in the following areas can be detected:
| *a | Vehicles in the following areas can be detected: |
| *b | Within approx. 5.5 to 20 m (18.05 to 65.62 ft) from the side of the vehicle (detection area changes according to vehicle speed) |
| *c | Within approx. 6 m (19.69 ft) behind the rear bumper |
| OPERATION OF OUTER REAR VIEW MIRROR INDICATOR AND RCTA BUZZER (BLIND SPOT MONITOR BUZZER) |
Initial check
When the blind spot monitor main switch (warning canceling switch assembly) is turned on with the ignition switch ON, the outer rear view mirror indicator on each outer rear view mirror assembly illuminates for 3 seconds and the RCTA buzzer (blind spot monitor buzzer) sounds for 1 second.
When the ignition switch is turned from off to ON with the blind spot monitor main switch (warning canceling switch assembly) on, the outer rear view mirror indicator on each outer rear view mirror assembly illuminates for 3 seconds.
Operation for each function
![]() |
Operation for blind spot monitor function
| *a | 0.125 seconds |
Operation for RCTA function

| *a | 0.125 seconds | *b | 2.5 seconds |
| *c | 0.1 seconds | *d | 0.4 seconds |
| *e | 2.3 seconds | - | - |