CHILD RESTRAINT SEAT TETHER ANCHOR (for TMC, TMMR Made) > REMOVAL |
| 1. PRECAUTION (w/ Rear Seat Side Airbag) |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag) |
| 3. REMOVE REAR SEAT HEADREST ASSEMBLY (for Fold Down Seat Type) |
| 4. REMOVE REAR SEATBACK ASSEMBLY LH (for Fold Down Seat Type) |
Disconnect the rear seat outer belt assembly from the rear seat center shoulder belt guide.
Fold down the rear seatback assembly LH.
![]() |
Disengage the fastener as shown in the illustration.
| *1 | Fastener |
w/o Seat Heater System:
![]() |
Remove the 2 bolts and rear seatback assembly LH.
w/ Seat Heater System:
![]() |
Remove the 2 bolts and disconnect the rear seatback assembly LH.
![]() |
Disconnect the connector.
Disengage the clamp and remove the rear seatback assembly LH.
| 5. REMOVE REAR SEAT HEADREST ASSEMBLY (for Fold Down Seat Type) |
| 6. REMOVE REAR SEATBACK ASSEMBLY RH (for Fold Down Seat Type) |
| 7. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
![]() |
Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
| a | 100 mm (3.94 in.) or less |
w/ Seat Heater System:
Disconnect the connector.
![]() |
Disengage the 2 clamps.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
| 8. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
| 9. REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type) |
Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide LH.
![]() |
Remove the bolt.
Disengage the hook and remove the rear side seatback assembly LH.
| 10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) |
Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide RH.
![]() |
Remove the bolt.
Disengage the hook and remove the rear side seatback assembly RH.
| 11. REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
![]() |
Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
| a | 100 mm (3.94 in.) or less |
Disconnect the 2 seat heater connectors.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
| 12. REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
| 13. REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type) |
| 14. REMOVE REAR SEATBACK COVER (for Reclining Seat Type) |
![]() |
Disengage the 4 claws and remove the 2 rear seatback covers.
| 15. REMOVE REAR SEATBACK ASSEMBLY LH (for Reclining Seat Type) |
w/ Rear Seat Side Airbag:
Disconnect each connector and clamp from the child restraint seat anchor bracket sub-assembly LH.
Disengage the 2 rear seat belts from the 2 rear seat shoulder belt guides.
![]() |
Disengage the 2 hooks and disconnect the cover.
Remove the 2 nuts, 2 bolts and rear seatback assembly LH.
| 16. REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type) |
| 17. REMOVE REAR SEATBACK COVER (for Reclining Seat Type) |
![]() |
Disengage the 4 claws and remove the 2 rear seatback covers.
| 18. REMOVE REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type) |
w/ Rear Seat Side Airbag:
Disconnect each connector and clamp from the child restraint seat anchor bracket sub-assembly RH.
Disengage the rear seat belt from the rear seat shoulder belt guide.
![]() |
Disengage the 2 hooks and disconnect the cover.
Remove the 2 nuts, 2 bolts and rear seatback assembly RH.
| 19. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY (for Reclining Seat Type) |
| 20. REMOVE CENTER SEATBACK ASSEMBLY (for Reclining Seat Type) |
Disconnect the connector.
![]() |
Remove the 2 bolts.
Disengage the hook and remove the center seatback assembly as shown in the illustration.
| 21. REMOVE REAR DOOR SCUFF PLATE LH (for Reclining Seat Type) |
![]() |
Disengage the 6 claws and remove the rear door scuff plate LH.
| 22. REMOVE REAR DOOR SCUFF PLATE RH (for Reclining Seat Type) |
| 23. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH |
Disconnect the rear door opening trim weatherstrip LH.
| 24. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH |
Disconnect the rear door opening trim weatherstrip RH.
| 25. REMOVE REAR SEAT SIDE GARNISH LH (for Reclining Seat Type) |
![]() |
Remove the bolt.
Disengage the claw, 2 clips and guide and remove the rear seat side garnish LH.
| 26. REMOVE REAR SEAT SIDE GARNISH RH (for Reclining Seat Type) |
| 27. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side) |
![]() |
Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.
| 28. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side) |
![]() |
Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.
| 29. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH |
Remove the 2 nuts and child restraint seat anchor bracket sub-assembly LH.

| *A | for Fold Down Seat Type (w/o Seat Heater System) | *B | for Fold Down Seat Type (w/ Seat Heater System) |
| *C | for Reclining Seat Type | - | - |
| 30. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH |
![]() |
Remove the bolt and disconnect the floor anchor of the rear seat inner with center belt assembly LH.
| 31. REMOVE ROOF SIDE INNER GARNISH LH |
![]() |
Disengage the 5 clips.
Disengage the guide and remove the roof side inner garnish LH.
| 32. REMOVE ROOF SIDE INNER GARNISH RH |
| 33. REMOVE CENTER STOP LIGHT SET (w/o Rear Sunshade) |
![]() |
Slide the center stop light set in the order and directions shown by the arrows in the illustration while pushing it towards the rear of the vehicle to disengage the 4 claws.
![]() |
Turn the center stop light set 180 degrees as shown by the arrow in the illustration.
Disconnect the connector and remove the center stop light set.
| 34. REMOVE REAR SEAT SHOULDER BELT COVER |
![]() |
Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.
| 35. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) |
![]() |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
| *a | Protective Tape |
Disengage the 5 guides.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
| 36. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) |
![]() |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
| *a | Protective Tape |
Disengage the guide.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
| 37. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET |
![]() |
Remove the bolt and child restraint seat tether anchor bracket.