WIPER SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT FRONT WIPER INTERMITTENT OPERATION (W/O AUTO WIPER SYSTEM) |
![]() |
for LHD:
| *a | Component with harness connected (Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).
Turn the ignition switch to ON.
Turn the wiper switch to the INT position.
Operate the intermittent wiper relay and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

| 2. INSPECT FRONT WASHER OPERATION (W/O AUTO WIPER SYSTEM) |
![]() |
for LHD:
| *a | Component with harness connected (Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

| 3. INSPECT FRONT WASHER OPERATION (W/ AUTO WIPER SYSTEM) |
![]() |
for LHD:
| *a | Component with harness connected (Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

![]() |
for RHD:
| *a | Component with harness connected (Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal I32-2 (+1) and a negative (-) lead to terminal I31-7 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals I32-2 (+1) and I31-7 (EW).
