Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH

BLIND SPOT MONITOR MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY)


    E224422E22
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    11 (B) - 8 (D)
    Blind spot monitor main switch (warning canceling switch assembly) on (not protruding)
    Below 1 Ω
    11 (B) - 8 (D)
    Blind spot monitor main switch (warning canceling switch assembly) off (protruding)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))
    If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).



  1. Check that the blind spot monitor indicator illuminates.



      E224422E23
    1. Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) connector and check operation of the blind spot monitor indicator, as shown in the table below.

      OK:
      Connection
      Condition
      Specified Condition
      Battery positive (+) → Terminal 11 (B)
      Battery negative (-) → Terminal 12 (E)
      Blind spot monitor main switch (warning canceling switch assembly) on (not protruding)
      Blind spot monitor indicator illuminates
      Blind spot monitor main switch (warning canceling switch assembly) off (protruding)
      Blind spot monitor indicator does not illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))
      If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).



  1. Check that the switch illuminates.



      E224422E24
    1. Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) and check that the switch illuminates.

      OK:
      Connection
      Specified Condition
      Battery positive (+) → Terminal 10 (ILL+)
      Battery negative (-) → Terminal 9 (ILL-)
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))
      If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).