Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (for TMMK Made)

DOOR CONTROL RECEIVER (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL DOOR CONTROL RECEIVER
  1. Install the door control receiver with the bolt.

  1. Connect the connector.



2. INSTALL ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedure for the RH side and LH side .



3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH


    B278983E02
  1. Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the vehicle body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.
    Text in Illustration 
    *a
    Alignment Mark (Blue)

    NOTICE:
    After installation, check that the corners fit correctly.



4. INSTALL REAR SIDE SEATBACK ASSEMBLY RH
  1. Engage the hook.

  1. Install the rear side seatback assembly RH with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the connector.

  1. Connect the rear seat outer belt assembly to the rear seat shoulder belt guide.



5. INSTALL REAR SEAT CUSHION LOCK HOOK


    B393388
  1. Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



6. INSTALL REAR SEAT CUSHION ASSEMBLY
  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.



    B280250
  1. Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.

  1. Confirm that the rear seat cushion assembly is securely installed.

    NOTICE:
    When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. INSPECT SRS WARNING LIGHT
(Click here)