Home › Vehicle Interior › SEAT › REAR SEAT CUSHION HEATER (for Reclining Seat Type)

REAR SEAT CUSHION HEATER (for Reclining Seat Type) > INSPECTION

for Preparation Click here



1. INSPECT REAR SEAT CUSHION HEATER (BENCH TYPE REAR SEAT CUSHION COVER)


  1. Inspect the rear seat cushion heater LH (bench type rear seat cushion cover).



      B283413E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Rear Seat Cushion Heater LH (Bench Type Rear Seat Cushion Cover))

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      A-1 - B-1
      Always
      Below 1 Ω
      A-2 - A-3
      Always
      3.92 to 4.7 Ω
      A-3 - A-5
      Always
      3.8 to 4.56 Ω
      A-4 - B-2
      Always
      Below 1 Ω

      If the result is not as specified, replace the rear seat cushion heater LH (bench type rear seat cushion cover).



  1. Inspect the rear seat cushion heater RH (bench type rear seat cushion cover).



      B283415E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Rear Seat Cushion Heater RH (Bench Type Rear Seat Cushion Cover))

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      A-1 - B-1
      Always
      Below 1 Ω
      A-1 - B-5
      Always
      3.92 to 4.7 Ω
      A-1 - A-2
      Always
      3.8 to 4.56 Ω
      A-2 - B-1
      Always
      3.8 to 4.56 Ω

      If the result is not as specified, replace the rear seat cushion heater RH (bench type rear seat cushion cover).