REAR SEAT CUSHION HEATER (for Fold Down Seat Type) > INSPECTION |
| 1. INSPECT REAR SEAT CUSHION HEATER (BENCH TYPE REAR SEAT CUSHION COVER) |
Inspect the rear seat cushion heater LH (bench type rear seat cushion cover).
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Rear Seat Cushion Heater LH (Bench Type Rear Seat Cushion Cover)) |
| Tester Connection | Condition | Specified Condition |
| A-1 - C-2 | Always | Below 0.1 Ω |
| A-2 - C-1 | Always | Below 0.1 Ω |
| A-3 - A-4 | Always | 3.8 to 4.56Ω |
| A-3 - B-1 | Always | 3.92 to 4.7 Ω |
| A-4 - B-2 | Always | 3.92 to 4.7 Ω |
Inspect the rear seat cushion heater RH (bench type rear seat cushion cover).
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Rear Seat Cushion Heater RH (Bench Type Rear Seat Cushion Cover)) |
| Tester Connection | Condition | Specified Condition |
| D-1 - D-2 | Always | Below 1 Ω |
| D-2 - E-1 | Always | 3.8 to 4.56Ω |
| D-1 - E-2 | Always | 3.92 to 4.7 Ω |