REAR SEATBACK HEATER (for Reclining Seat Type) > INSTALLATION |
| 1. INSTALL SEPARATE TYPE REAR SEATBACK COVER (REAR SEATBACK HEATER SUB-ASSEMBLY) |
![]() |
Using hog ring pliers, install the separate type rear seatback cover (rear seatback heater sub-assembly) to the separate type rear seatback pad with 10 new hog rings.
| 2. INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD |
Temporarily install the separate type rear seatback cover with pad to the rear seatback frame sub-assembly LH.
Engage the clamp to connect the seat heater wire harness to the rear seatback frame sub-assembly LH.
![]() |
Engage the 4 claws to install the 2 rear seat headrest supports.
w/ Rear Seat Side Airbag:
![]() |
Install the airbag bracket with the nut.
![]() |
Using hog ring pliers, install 12 new hog rings.
Engage each hook to install the separate type rear seatback cover with pad.
| 3. INSTALL REAR SEAT SHOULDER BELT GUIDE |
![]() |
Engage the guide.
Install the rear seat shoulder belt guide LH with the 2 screws.
| 4. INSTALL REAR SEAT CENTER SHOULDER BELT GUIDE (for LH Side) |
![]() |
Engage the guide.
Install the rear seat center shoulder belt guide with the 2 screws.
| 5. INSTALL REAR SEATBACK ASSEMBLY |
Place the rear seatback assembly LH in the cabin.
Install the rear seatback assembly LH with the 2 bolts and 2 nuts.
Engage the 2 hooks to install the cover.
Connect the 2 rear seat belts to the 2 rear seat shoulder belt guides.
w/ Rear Seat Side Airbag:
Connect each connector and clamp to the child restraint anchor bracket sub-assembly LH.
| 6. INSTALL REAR SEATBACK COVER |
Engage the 4 claws to install the 2 rear seatback covers.
| 7. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 8. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.
Connect the 2 seat heater connectors.
![]() |
Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.
Confirm that the rear seat cushion assembly is securely installed.
| 9. INSTALL REAR SEAT HEADREST ASSEMBLY |
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag) |
| 11. INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag) |