Home › Vehicle Interior › SEAT › REAR SEAT CUSHION HEATER (for Reclining Seat Type)

REAR SEAT CUSHION HEATER (for Reclining Seat Type) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B290774E01
  1. Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Be sure to hold the part of the rear seat cushion assembly directly next to the rear seat cushion lock hooks when lifting it up. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.

  1. Disconnect the 2 seat heater connectors.

  1. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



2. REMOVE REAR SEAT CUSHION LOCK HOOK


    B393387
  1. Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



3. REMOVE BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER SUB-ASSEMBLY)


  1. Remove the 40 hog rings.


    B281582



  1. Remove the 24 hog rings and bench type rear seat cushion cover (rear seat cushion heater sub-assembly) from the bench type rear seat cushion pad.


    B281584