CAN COMMUNICATION SYSTEM > PRECAUTION |
| 1.NOTICE FOR INITIALIZATION |
| System | See Procedure |
| Parking Assist Monitor System |
Click here
|
| 2.CAN COMMUNICATION SYSTEM TROUBLESHOOTING |
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (Click here).
| 3.IGNITION SWITCH EXPRESSIONS |
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
| 4.PRECAUTIONS FOR STEERING SYSTEM HANDLING |
Be careful when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.
| 5.PRECAUTIONS FOR SRS AIRBAG SYSTEM HANDLING |
This vehicle is equipped with a Supplemental Restraint System (SRS) which includes parts such as airbags for the driver and front passenger. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may cause a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read Precaution for SRS .
(for TMC, TMMR Made Click here)
(for TMMK Made Click here)
| 6.BUS LINE REPAIR |
![]() |
After repairing a bus line with solder, wrap the repaired part with electrical tape.
![]() |
Do not use bypass wiring between connectors.
| *a | Bypass Wire |
| 7.CONNECTOR HANDLING |
![]() |
When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.
| *a | Tester Probe |
![]() |
Use service wires to check the connector if it is impossible to check continuity from the rear of the connector.
| *a | Service Wire |
| 8.PRECAUTIONS FOR INSPECTING OR REPLACING CAN JUNCTION CONNECTOR |
If the CAN junction connector is removed from the vehicle for inspection or replacement, make sure to install the CAN junction connector and all wire harnesses to their original locations with tape and clamps.
| 9.PRECAUTIONS WHEN REPLACING A GATEWAY FUNCTION EQUIPPED ECU (SUB BUS MONITOR ECU) WITH A USED ONE FROM ANOTHER VEHICLE |
When a gateway function equipped ECU (main body ECU (multiplex network body ECU) or network gateway ECU) that was previously installed on another vehicle is used as a replacement part, it is necessary to initialize the connection information stored in the ECU.
Initialize the connection information of a gateway function equipped ECU (sub bus monitor ECU).
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body or Gateway / Utility.
Select Initialization from Utility to initialize the ECU.
| 10.PRECAUTIONS FOR WHEN GATEWAY FUNCTION EQUIPPED ECU (SUB BUS MONITOR ECU) DETECTS COMMUNICATION DTCS FOR ECUS NOT CONNECTED TO THE ECU |
Refer to Precautions When Replacing a Gateway Function Equipped ECU (Sub Bus Monitor ECU) with a Used One from Another Vehicle and initialize the connection information of the ECU.
Clear the DTCs and check that no DTCs are output.