Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > INSTALLATION

for Preparation Click here


NOTICE:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. INSTALL OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    B301249
  1. Using hog ring pliers, install the occupant detection sensor (separate type front seat cushion pad) to the separate type front seat cushion cover with 18 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seat cushion cover.



    B279525
  1. Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seat cushion cover.



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure as for the driver seat .



3. INSTALL FRONT SEAT INNER BELT ASSEMBLY


  1. w/o Seat Belt Warning System:



      B279435E02
    1. Install the front seat inner belt assembly with the nut.
      Text in Illustration 
      *a
      Protruding Part

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.



  1. w/ Seat Belt Warning System:



      B293719E03
    1. Install the front seat inner belt assembly with the nut.
      Text in Illustration 
      *a
      Protruding Part

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

    2. Engage each clamp under the front seat assembly.

    3. Connect the connector under the front seat assembly.



4. INSTALL FRONT SEAT INNER CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat .



5. INSTALL FRONT SEAT CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat .



6. INSTALL FRONT NO. 1 SEAT INNER CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat .



7. CONNECT SEPARATE TYPE FRONT SEATBACK COVER

HINT:
Use the same procedure as for the driver seat .



8. INSTALL RECLINING POWER SEAT SWITCH KNOB

HINT:
Use the same procedure as for the driver seat .



9. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

HINT:
Use the same procedure as for the driver seat .



10. INSTALL FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver seat .