Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > REMOVAL

for Preparation Click here


NOTICE:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

HINT:
Use the same procedure as for the driver seat .



3. REMOVE RECLINING POWER SEAT SWITCH KNOB

HINT:
Use the same procedure as for the driver seat .



4. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

HINT:
Use the same procedure as for the driver seat .



5. REMOVE FRONT NO. 1 SEAT INNER CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat .



6. REMOVE FRONT SEAT CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat



7. REMOVE FRONT SEAT INNER CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat



8. REMOVE FRONT SEAT INNER BELT ASSEMBLY


  1. w/o Seat Belt Warning System:



      B279434
    1. Remove the nut and front seat inner belt assembly.



  1. w/ Seat Belt Warning System:

    1. Disconnect the connector under the front seat assembly.

    2. Disengage each clamp under the front seat assembly.



    3. B293718
    4. Remove the nut and front seat inner belt assembly.



9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure as for the driver seat .



10. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    B279522
  1. Remove the 2 hog rings.



    B301248
  1. Remove the 18 hog rings and occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover.