Home › Drivetrain · U760E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for TMMK Made)

SHIFT LEVER (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT LOWER SHIFT LEVER ASSEMBLY


    C239819E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    5 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    Engine switch off
    Below 1 V
    4 (STP) - Body ground
    Brake pedal depressed
    11 to 14 V
    Brake pedal released
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Shift Lock Control ECU)

    HINT:
    Do not disconnect the shift lock control ECU connector.



    C239819E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component with harness connected
    (Shift Lock Control ECU)

    HINT:
    Do not disconnect the shift lock control ECU connector.



  1. Inspect shift lock solenoid:



      C239826
    1. Disconnect the shift lock solenoid connector.



    2. C197452E09
    3. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

      Standard Resistance:
      Tester Connection
      Shift Lever Position
      Specified Condition
      4 (P) - 3 (E2)
      P
      10 kΩ or higher
      4 (P) - 3 (E2)
      Other than P
      Below 1 Ω

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Shift Lock Solenoid)
      1. If the result is not as specified, replace the lower shift lever assembly.
      2. If the shift lock does not operate when the power source of the lower shift lever assembly is normal and the resistance between the body ground and shift lock solenoid is as specified, replace the lower shift lever assembly.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (SLS+) - 2 (SLS-)
      Always
      112 Ω

      1. If the result is not as specified, replace the lower shift lever assembly.
      2. If the shift lock does not operate when the power source of the lower shift lever assembly is normal and the resistance between the body ground and shift lock solenoid is as specified, replace the lower shift lever assembly.