Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM

AUTOMATIC HIGH BEAM SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE AUTOMATIC HIGH BEAM SYSTEM

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:
The following item can be customized.

  1. Customizing with the GTS

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Customize Setting / Light Control.

    5. Select the setting by referring to the table below.

      Light Control 
      Display
      Default
      Content
      Setting
      Relevant ECU
      Automatic High Beam
      On
      Enabling (On) or disabling (Off) of the automatic high beam function
      On or Off
      Main Body ECU (Multiplex Network Body ECU)