WIRELESS CHARGING SYSTEM > SYSTEM DESCRIPTION |
| WIRELESS CHARGER FUNCTION OUTLINE |
The wireless charging system enables Qi-compatible* rechargeable devices, such as a cellular phone, to be recharged by merely placing it on the charging area of the mobile wireless charger cradle assembly.
Qi-compatible devices which do not fit within the charging area cannot be used. If a Qi-compatible device does not operate normally, refer to the owner's manual of the device.
Qi-compatible rechargeable devices can be charged.
| CHARGING INDICATOR STATUS |
![]() ![]() |
The indicator light shows the operation condition of the wireless charging system.
| *a | Indicator Light (Green/Amber) |
| *b | Mobile Wireless Charger Switch |
| *c | Charging Area |
| Indicator Light | Operation Condition | |
| Condition | Color | |
| Off | - | Wireless charging system is turned off |
| On | Green |
|
| On | Amber |
|
| On (For 4.5 sec)*2 | Green | Charging is stopped temporarily due to a charging suspension signal being received from the smart entry & start system |
| Blinks (Pattern 1) *3 | Amber | An open in the charging suspension signal circuit is detected |
| Blinks (Pattern 2)*3 | Amber | The charging frequency is being changed |
| Blinks (Pattern 3)*3 | Amber |
|
| Blinks (Pattern 4)*3 | Amber | The temperature of the mobile wireless charger cradle assembly is abnormally high |
| RESUMPTION OF CHARGING |
After charging is complete, if the rechargeable device is left in the same position on the charging area, charging will resume after 30 minutes elapse.
Charging will resume if the rechargeable device is moved or repositioned within the charging area, or replaced with another rechargeable device within 30 minutes of charging being completed.
If the rechargeable device is moved while it is being charged, charging will resume when the device is placed on the charging area.
| SUSPENSION OF CHARGING DUE TO VERIFICATION OF ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY |
The wireless charging system uses the same radio wave frequency that is used to perform verification of the electrical key transmitter sub-assembly. Therefore, when the electrical key transmitter sub-assembly verification is being performed, the certification ECU (smart key ECU assembly) sends a charging suspension signal to the wireless charging system to suspend charging.
The certification ECU (smart key ECU assembly) sends the charging suspension signal when any of the following conditions is met:
| CHARGING FREQUENCY SWITCHING FUNCTION |
If noise is generated in the AM radio during charging, turn the wireless charging system off and check if the noise is reduced. If the noise is reduced, press and hold the mobile wireless charging switch for approximately 2 seconds to change the charging frequency and reduce the noise.