DTC B158F AV Signal Stoppage (Low Battery Voltage) |
| DTC No. | DTC Detection Condition | Trouble Area |
| B158F | A video or audio signal is interrupted when the battery voltage drops | Navigation receiver assembly |

| 1.CHECK VEHICLE SIGNAL (OPERATION CHECK) |
![]() |
Enter the "Vehicle Signal Check Mode" screen.
Refer to Check Vehicle Signal in Operation Check (Click here).
Check the battery voltage.
|
| ||||
| OK | |
| 2.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
| OK | A |
| NG (for TMMK Made) | B |
| NG (for TMC Made) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE) |
Disconnect the I64 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I64-4 (+B1) - Body ground | Always | 11 to 14 V |
| Result | Proceed to |
| NG | A |
| OK (for TMMK Made) | B |
| OK (for TMC Made) | C |
|
| ||||
|
| ||||
| A | ||
| ||