DTC B2795 Unmatched Key Code |
| DTC No. | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2795 | A door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). |
| Insert the door control transmitter assembly into the ignition key cylinder, turn the ignition switch from off to ON and wait at least 20 seconds. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
| B2795 | - |
| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Perform "DTC Output Confirmation Operation" procedure.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B2795 is output for any of the door control transmitter assemblies | A |
| DTC B2795 is output for all of the door control transmitter assemblies | B |
| B2795 is not output | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK OPERATION (IG ON) |
Check that the ignition switch can be turned to ON using the door control transmitter assembly for which the DTC was stored.
|
| ||||
| OK | |
| 4.REGISTRATION |
Clear the DTCs (Click here).
Register the key ID code with the transponder key ECU assembly.
|
| ||||
| OK | ||
| ||