Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BODY SIDE PANEL PROTECTOR

REAR BODY SIDE PANEL PROTECTOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR OUTER PILLAR GARNISH SUB-ASSEMBLY

HINT:
When installing the rear outer pillar garnish sub-assembly, heat the vehicle body and rear outer pillar garnish sub-assembly using a heat light.

Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Outer Pillar Garnish Sub-assembly
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body, rear outer pillar garnish sub-assembly excessively.

  1. Clean the vehicle body.

    1. Remove any remaining double-sided tape from the vehicle body.

    2. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from a new rear outer pillar garnish sub-assembly.

    HINT:
    After removing the release paper, keep the exposed adhesive free from foreign matter.



    B401432E01
  1. Engage the 6 clips to install the rear outer pillar garnish sub-assembly.
    Text in Illustration 
    *a
    Double-sided Tape