Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BODY SIDE PANEL PROTECTOR

REAR BODY SIDE PANEL PROTECTOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE REAR OUTER PILLAR GARNISH SUB-ASSEMBLY

HINT:
When removing the rear outer pillar garnish sub-assembly, heat the vehicle body and rear outer pillar garnish sub-assembly using a heat light.

Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Outer Pillar Garnish Sub-assembly
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body, rear outer pillar garnish sub-assembly excessively.



    B380987
  1. Apply protective tape around the rear outer pillar garnish sub-assembly as shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape



    B401430
  1. Disengage the 6 clips to remove the rear outer pillar garnish sub-assembly.