Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM

DTC    B2461    Vehicle Information not written in AHB ECU

for Preparation Click here


DESCRIPTION

The inner rear view mirror assembly stores this DTC if initialization has not been performed after the ECU was replaced.

DTC No.
DTC Detection Condition
Trouble Area
B2461
Vehicle information not written in AHB ECU
  1. Inner rear view mirror assembly
  2. Main body ECU (multiplex network body ECU)
  3. CAN communication system

INSPECTION PROCEDURE

NOTICE:
Confirm that the CAN communication system is not malfunctioning before performing the following inspection (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2461 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result:

    Result
    Proceed to
    CAN communication system DTCs are not output
    A
    CAN communication system DTCs are output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


3.INSPECT INNER REAR VIEW MIRROR ASSEMBLY
  1. Replace the inner rear view mirror assembly with a new or known good one (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2461 is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (INNER REAR VIEW MIRROR ASSEMBLY WAS DEFECTIVE)