AUTOMATIC TRANSAXLE FLUID > HIGH TEMPERATURE ADJUSTMENT |
| 1. ADJUST FLUID LEVEL AT HIGH TEMPERATURE |
Warm up and stop the engine. [#4]
Connect the intelligent tester to the DLC3 with the Ignition switch off.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List / Engine Speed and A/T Oil Temperature 1.
Check the ATF temperature.
Depress and hold the brake pedal.
Start the engine.
Slowly move the shift lever from P to D, and then back to P.
Lift the vehicle.
Remove the front wheel opening extension pad LH .
Remove the engine under cover LH .
Remove the front fender apron seal LH .
![]() |
Loosen the refill plug.
![]() |
Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly. [#1]
![]() |
Make sure that the automatic transaxle fluid temperature and engine speed remain within the appropriate range until the overflow plug is tightened in step [#2].
| *a | Automatic Transaxle Fluid Temperature [°C (°F)] |
| *b | Engine Idle Speed (rpm) |
| *c | Remove the Overflow Plug. |
| *d | Install the Overflow Plug. |
| *e | Time |
| *f | Example: When adjusting with the engine idle speed between 600 and 700 rpm |
![]() |
Wait until the automatic transaxle fluid flow slows and only drips come out.
Using a 6 mm hexagon socket wrench, install a new gasket and the overflow plug to the automatic transaxle oil pan sub-assembly. [#2]
Lower the vehicle.
Turn the ignition switch off.
![]() |
Remove the refill plug and gasket from the rear transaxle cover sub-assembly.
![]() |
Install a hose and funnel to the refill hole as shown in the illustration.
Add the specified amount of automatic transaxle fluid to the refill hole. [#3]
If determining the specific amount of automatic transaxle fluid to be added, refer to the table below.
| Specified Amount to be Added at Automatic Transaxle Fluid Temperature of 85°C (185°F) to 90°C (194°F) | |
| Engine Idle Speed (rpm) 600 to 700 | Engine Idle Speed (rpm) 700 to 800 |
| 600 g (21.2 oz) 700 cc (42.7 cu. in.) | 540 g (19.0 oz) 640 cc (39.1 cu. in.) |

| *a | Density [g / cc] | *b | Temperature of automatic transaxle fluid to be measured [°C (°F)] |
| *c | Relation between temperature and density of Toyota genuine ATF WS | - | - |
![]() |
Install a new gasket and the refill plug to the rear transaxle cover sub-assembly.
Remove the intelligent tester from the DLC3.
| 2. REBUILD WORK |
Lift the vehicle.
Clean each part.
Check for automatic transaxle fluid leaks.
Install the front fender apron seal LH .
Install the engine under cover LH .
Install the front wheel opening extension pad LH .
Lower the vehicle.