DTC P1604 Startability Malfunction |
| DTC No. | DTC Detection Condition |
| P1604 | Either conditions is met:
|

| Trouble Area | |
| Ignition system |
|
| Fuel system |
|
| Intake and exhaust systems |
|
| Other control systems |
|
| Engine |
|
| High load from another system |
|
| 1.CHECK FOR ANY OTHER DTCS OUTPUT |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P1604 is output | A |
| DTC P1604 and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ FREEZE FRAME DATA (IMMOBILISER COMMUNICATION AND IMMOBILISER FUEL CUT) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Using the GTS, confirm the vehicle conditions recorded in the freeze frame data which were present when the DTC was stored (Click here).
| Data List Item | GTS Display |
| Immobiliser Communication | ON |
| Immobiliser Fuel Cut | OFF |
|
| ||||
| OK | |
| 3.READ FREEZE FRAME DATA (ISC LEARNING VALUE) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Using the GTS, confirm the vehicle conditions recorded in the freeze frame data which were present when the DTC was stored (Click here).
| Freeze Frame Data Item | Result | Suspected Area | Action | Proceed to |
| ISC Learning Value | Less than 8.5 L/s | - | Go to the next step | A |
| 8.5 L/s or higher | Throttle body with motor assembly | Go to Engine Difficult to Start (from step 15) | B |
|
| ||||
| A | |
| 4.READ FREEZE FRAME DATA (ENGINE SPEED) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Using the GTS, confirm the vehicle conditions recorded in the freeze frame data which were present when the DTC was stored (Click here).
| Freeze Frame Data Item | Result | Suspected Area | Action | Proceed to |
| Engine Speed | All 5 sets of freeze frame data are 0 rpm (engine did not crank or engine speed was not detected properly) |
| Go to Engine Difficult to Start (from step 5) | A |
| 100 to 500 rpm (engine cranked but initial combustion did not occur or was delayed) |
| Go to the next step | B | |
| 500 rpm or higher (engine speed dropped immediately after initial combustion) (Low Rev for Eng Start is ON) |
|
|
| ||||
| A | ||
| ||
| 5.INTERVIEW THE CUSTOMER |
Interview the customer for details about the conditions when the malfunction occurred.
| Result | Suspected Area | Action | Proceed to |
| Engine is difficult to start only when the vehicle has been left as is for a long time (1 hour or more) | Leaking fuel injector assembly | Go to Engine Difficult to Start (from step 4) | A |
| Other than above |
| Go to the next step | B |
|
| ||||
| A | ||
| ||
| 6.INTERVIEW THE CUSTOMER |
Interview the customer for details about the conditions when the malfunction occurred.
| Result | Suspected Area | Action | Proceed to |
| Mostly driven short distances |
| Go to Engine Difficult to Start (from step 13) | NEXT |
| Not mostly driven short distances |
| Go to Engine Difficult to Start (from step 9) |
| NEXT | ||
| ||