DTC P056014 System Voltage Circuit Short to Ground or Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P056014 | An open or short in the ECM backup power source circuit (1 trip detection logic). |
|
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| Both of the following conditions are met | - |
| Battery voltage (BATT) | Below 3.5 V |
| Electronic throttle actuator power supply voltage (+BM) | Below 3.5 V |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT BATTERY |
Inspect the battery .
|
| ||||
| OK | |
| 2.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SOURCE OF ECM) |
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A84-1 (BATT) - Body ground | Always | 11 to 14 V |
| E96-48 (+BM) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P056014) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG).
Turn the GTS on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P056014 is output | A |
| DTCs are not output | B |
|
| ||||
| A | ||
| ||