DTC P060604 Control Module Processor System Internal Failure |
DTC P060629 Control Module Processor Signal Invalid |
DTC P060647 Control Module Processor Watchdog/Safety MCU Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060604 | ECM main CPU malfunction (1 trip detection logic). | ECM |
| P060629 | ECM main CPU malfunction (1 trip detection logic). | ECM |
| P060647 | ECM main CPU malfunction (1 trip detection logic). | ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060604, P060629 OR P060647) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the GTS off.
Turn the engine switch off.
Disconnect the GTS.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Wait for 1 second or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTCs are not output | A |
| DTC P060604, P060629 and/or P060647 is output | B |
|
| ||||
| A | ||
| ||