Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT V-RIBBED BELT


    B000543
  1. Check the V-ribbed belt for wear, cracks or other signs of damage.
    If any of the following defects is found, replace the V-ribbed belt.

    1. The V-ribbed belt is cracked.
    2. The V-ribbed belt is worn out to the extent that the cords are exposed.
    3. The V-ribbed belt has chunks missing from the ribs.



    A087787E20
  1. Check that the V-ribbed belt fits properly in the ribbed grooves.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    HINT:
    Check with your hand to confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.