Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE INTAKE VALVE


    A337935E01
  1. Using SST, compress the compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020  
    09202-00020  

  1. Remove the valve spring retainer, compression spring and intake valve from the cylinder head sub-assembly.

    HINT:
    Arrange the removed parts in the correct order.



2. REMOVE EXHAUST VALVE


    A337936E01
  1. Using SST, compress the compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020  
    09202-00020  

  1. Remove the valve spring retainer, compression spring and exhaust valve from the cylinder head sub-assembly.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE VALVE STEM OIL SEAL


    A194958
  1. Using needle-nose pliers, remove the valve stem oil seals.



4. REMOVE VALVE SPRING SEAT


    A194959
  1. Using compressed air and a Magnet Hand, remove the valve spring seats by blowing air onto them.



5. REMOVE NO. 1 STRAIGHT SCREW PLUG

NOTICE:
If coolant leaks from a No. 1 straight screw plug or the plug is corroded, replace it.



    A337937
  1. Using a 10 mm hexagon wrench, remove the 3 No. 1 straight screw plugs and 3 gaskets.



6. REMOVE NO. 2 STRAIGHT SCREW PLUG

NOTICE:
If coolant leaks from the No. 2 straight screw plug or the plug is corroded, replace it.



    A194961
  1. Using a 14 mm hexagon wrench, remove the No. 2 straight screw plug and gasket.



7. REMOVE CYLINDER HEAD STUD BOLT

NOTICE:
If a cylinder head stud bolt is deformed or its threads are damaged, replace it.