Home › Engine / Hybrid System · 6AR-FSE › FUEL › FUEL INJECTOR (for Direct Injection)

FUEL INJECTOR (for Direct Injection) > INSPECTION

for Preparation Click here



1. INSPECT DIRECT FUEL INJECTOR ASSEMBLY

NOTICE:
This inspection aims at checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assemblies of this vehicle are a high-pressure type, fuel injection volume cannot be checked.



    A333795E02
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Direct fuel injector Assembly)
    Standard Resistance: 
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    1.74 to 2.04 Ω
    If the result is not as specified, replace the direct fuel injector assembly.