Home › Engine / Hybrid System ยท 6AR-FSE › FUEL › FUEL PRESSURE SENSOR

FUEL PRESSURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL PRESSURE SENSOR

NOTICE:
  1. Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
  1. If the fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.



  1. Check the fuel pressure sensor output voltage.



      A330384E01
    1. Apply 5 V between terminals 1 (VC) and 2 (E2).
      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pressure Sensor)
      *b
      Voltage applied between terminals

      NOTICE:
      1. Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
      1. Do not apply more than 6 V to terminals 1 (VC) and 2 (E2).

      HINT:
      If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



    2. A326513E01
    3. Measure the voltage between terminals.
      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pressure Sensor)
      Standard Voltage: 
      Tester Connection
      Condition
      Specified Condition
      3 (PR) - 2 (E2)
      Pressure not applied to fuel pressure sensor
      Approximately
      0.4 to 0.6 V*
      *: The output voltage changes depending on the voltage applied to the terminals. If the result is not as specified, replace the fuel delivery pipe sub-assembly (fuel pressure sensor).