Home › Engine / Hybrid System · 6AR-FSE › FUEL › FUEL PUMP (for High Pressure)

FUEL PUMP (for High Pressure) > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP WITH SEAL SUB-ASSEMBLY


    A333796E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Pump with Seal Sub-assembly)
    Standard Resistance: 
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    0.5 Ω
    If the result is not as specified, replace the fuel pump with seal sub-assembly.