Home › Engine / Hybrid System ยท 6AR-FSE › FUEL › FUEL PUMP (for High Pressure)

FUEL PUMP (for High Pressure) > ON-VEHICLE INSPECTION

for Preparation Click here



1. FUEL PUMP WITH SEAL SUB-ASSEMBLY OPERATION
  1. Check fuel pressure.

    1. Connect the GTS to the DLC3.

    2. Start the engine.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset / Fuel Pressure (High).

    5. Check that the fuel pressure fluctuates when the target fuel pressure changes.

      HINT:
      The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.
      If the result is not as specified, replace the fuel pump with seal sub-assembly or fuel pressure sensor.

  1. Check operating sound.

    1. Remove the No. 1 engine cover sub-assembly .

    2. Remove the fuel pump protector .

    3. Start the engine.

    4. Using a sound scope, check the operating sound of the fuel pump with seal sub-assembly.
      If no sound can be heard, check the fuel pump with seal sub-assembly, wire harness and ECM.

    5. Stop the engine.

    6. Install the fuel pump protector .

    7. Reinstall the No. 1 engine cover sub-assembly .