DTC P160700 Cruise Control Input Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P160700 | Cruise control active signal inconsistency between Main-CPU and Sub-CPU for 0.3 seconds or more. | ECM |
| 1.CHECK FOR DTCS (CRUISE CONTROL SYSTEM DTC P160700) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC P160700 is not output | A |
| DTC P160700 is output | B |
|
| ||||
| A | ||
| ||