Home › Engine / Hybrid System ยท 6AR-FSE › LUBRICATION › OIL LEVEL SENSOR

OIL LEVEL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL LEVEL SENSOR
  1. Install the engine oil level sensor with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the clamp.

  1. Install a new clip to the engine oil level sensor.

  1. Connect the engine oil level sensor connector.



2. INSTALL OIL PAN SUB-ASSEMBLY


    A210205E02
  1. Apply seal packing in a continuous line as shown in the illustration.
    Text in Illustration 
    *a
    Seal Packing

    Seal Packing:
    Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

    Standard Seal Packing Diameter:
    2.5 to 3.5 mm (0.0984 to 0.138 in.)

    NOTICE:
    1. Remove any oil from the contact surface.
    2. Install the oil pan sub-assembly within 3 minutes and tighten the bolts and nuts within 10 minutes of applying seal packing.
    3. Do not start the engine for at least 2 hours after installation.



    A337281E03
  1. Install the oil pan sub-assembly with the 11 bolts and 2 nuts in several steps, in the order shown in the illustration.
    Text in Illustration 
    *A
    Type A
    *B
    Type B
    V100135
    Bolt
    V100136
    Nut

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    HINT:
    The bolt (A) and nut (A) are tightened twice.



3. INSTALL ENGINE ASSEMBLY
(Click here)