Home › Engine / Hybrid System ยท 6AR-FSE › LUBRICATION › OIL LEVEL SENSOR

OIL LEVEL SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY
(Click here)


2. REMOVE OIL PAN SUB-ASSEMBLY


    A337281E01
  1. Remove the 11 bolts and 2 nuts.
    Text in Illustration 
    *A
    Type A
    *B
    Type B
    V100135
    Bolt
    V100136
    Nut



    A118769
  1. Insert the blade of an oil pan seal cutter between the oil pan sub-assembly and stiffening crankcase assembly, cut through the applied sealer and remove the oil pan sub-assembly.

    NOTICE:
    1. Be careful not to damage the stiffening crankcase assembly contact surface of the oil pan sub-assembly.
    2. Be careful not to damage the oil pan sub-assembly flange.



3. REMOVE ENGINE OIL LEVEL SENSOR
  1. Disconnect the engine oil level sensor connector.



    A338624
  1. Remove the clip from the engine oil level sensor.



    A338625
  1. Remove the 2 bolts.

  1. Disengage the clamp to remove the engine oil level sensor.