Home › Engine / Hybrid System ยท 6AR-FSE › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A315230E01
  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover LH
    *a
    Hose

  1. Loosen the radiator drain cock plug.



    A338632E01
  1. Remove the radiator cap sub-assembly. Then drain the engine coolant.
    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Disconnect the hose from the radiator drain cock.



2. DRAIN ENGINE OIL
  1. Remove the oil filler cap sub-assembly.

  1. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

  1. Clean the oil pan drain plug.

  1. Install a new gasket to the oil pan drain plug.

  1. Install the oil pan drain plug.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



3. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    A337909
  1. Remove the engine oil level dipstick.

  1. Remove the bolt and engine oil level dipstick guide.

  1. Remove the O-ring from the engine oil level dipstick guide.



4. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
(Click here)


5. REMOVE OIL COOLER ASSEMBLY


    A207599E07
  1. Remove the oil cooler union bolt and seal washer.
    Text in Illustration 
    *1
    Oil Cooler Union Bolt
    *2
    Seal Washer

  1. Remove the nut and oil cooler assembly from the water inlet housing.

  1. Remove the 3 gaskets from the oil cooler assembly.