Home › Power Source / Network ยท 6AR-FSE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the A/C switch off.

  3. Turn the engine switch off.

  4. Connect the GTS to the DLC3.

  5. Turn the engine switch on (IG).

  6. Turn the GTS on.

  7. Enter the following menus: Powertrain / Engine / Data List.

  8. According to the display on the GTS, read the Data List.

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Battery Voltage
    Battery voltage /
    Min.: 0.0 V, Max.: 65.5 V
    11 to 14 V (Idling)
    If the result is not as specified, abnormal battery voltage is suspected.
    BATT Voltage
    BATT voltage /
    Min.: 0.0 V, Max.: 79.998 V
    11 to 14 V (Idling)
    -
    Alternator Output Duty Ratio
    Generator output duty /
    Min.: 0.0%, Max.: 399.9%
    Changes according to alternator output
    If the result is not as specified, a malfunction of the charging system is suspected.
    Alternator Voltage - Non Active Test
    Requested voltage when regulator forced drive is not executed
    Min.: 0.0 V, Max.: 79.998 V
    12.5 to 14.4 V: After engine start (varies with battery temperature or driving conditions)
    Active Test support data
    Voltage of Alternator
    Voltage of Alternator /
    Min.: 0.0 V, Max.: 79.9 V
    -
    -

    HINT:
    Normal Condition: If no idling conditions are specified, the shift lever should be in N (Neutral) or P, and the A/C switch and all accessory switches should be off.


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine / Active Test.

  5. According to the display on the GTS, perform the Active Test.

    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Control the Voltage of Alternator
    Requested output voltage of generator regulator during forced activation
    Between 12.5 and 14.8 V
    Test is possible after engine start