Home › Engine / Hybrid System · 6AR-FSE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE (for Exhaust Side)

CAMSHAFT OIL CONTROL VALVE (for Exhaust Side) > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the camshaft timing oil control valve assembly.



  1. Check the operation.



      A309601E01
    1. Connect a battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the spool valve.
      Text in Illustration 
      *a
      Component without harness connected
      (Camshaft Timing Oil Control Valve Assembly)
      *b
      When Battery Voltage Applied
      *c
      When Battery Voltage Cut Off
      *d
      Spool Valve

      OK:
      Condition
      Specified Condition
      Battery voltage applied
      Valve moves in left arrow direction shown in illustration
      Battery voltage cut off
      Valve moves in right arrow direction shown in illustration

      NOTICE:
      Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks in the exhaust side oil control valve will cause the exhaust camshaft to retard. The inappropriate camshaft timing that results from these leaks will cause a DTC to be stored.

      If the result is not as specified, replace the camshaft timing oil control valve assembly.