Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE (for Exhaust Side)

CAMSHAFT OIL CONTROL VALVE (for Exhaust Side) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A337988
  1. Disconnect the camshaft timing oil control valve assembly connector.

  1. Remove the bolt and camshaft timing oil control valve assembly from the cylinder head cover sub-assembly.

    NOTICE:
    1. Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).
    2. If the camshaft timing oil control valve assembly has been struck or dropped, replace it.



    A283726E02
  1. Remove the O-ring from the camshaft timing oil control valve assembly.
    Text in Illustration 
    *1
    O-ring