Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › CAMSHAFT OIL CONTROL SOLENOID

CAMSHAFT OIL CONTROL SOLENOID > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE EARTH WIRE


    A338526
  1. Remove the 2 bolts and earth wire.



3. REMOVE NO. 2 ENGINE MOUNTING STAY RH


    A338525
  1. Remove the 2 bolts and No. 2 engine mounting stay RH.



4. REMOVE ENGINE MOVING CONTROL ROD BRACKET


    A338527
  1. Remove the 4 bolts and engine moving control rod bracket.



5. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY


    A337990
  1. Disconnect the camshaft timing oil control solenoid assembly connector.

  1. Remove the 2 bolts and camshaft timing oil control solenoid assembly from the timing chain cover sub-assembly.

    NOTICE:
    If the camshaft timing oil control solenoid assembly has been struck or dropped, replace it.



    A337991
  1. Remove the O-ring from the camshaft timing oil control solenoid assembly.

    NOTICE:
    1. If the O-ring comes off in the timing chain cover sub-assembly, make sure to remove it.
    2. Do not drop the O-ring into the timing chain cover sub-assembly.