Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY
  1. Check the idle speed.

    1. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

      Standard:
      600 to 700 rpm

      NOTICE:
      1. Be sure to perform this step with all accessories off.
      2. Make sure that the shift lever is in P.

    2. Perform a road test and confirm that there are no abnormalities.

  1. Inspect the throttle position sensor.

    1. Connect the GTS to the DLC3.

    2. Start the engine.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position.

    5. Depress the accelerator pedal. When the throttle valve is fully open, check that the Throttle Sensor Position value is as specified.

      Standard Throttle Valve Opening Percentage:
      GTS Display
      Specified Condition
      Throttle Sensor Position
      60% or higher

      NOTICE:
      1. When checking the throttle valve opening percentage, the shift lever should be in N.
      2. Fully depress the accelerator pedal.

      If the percentage is less than 60%, replace the throttle body with motor assembly.