Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A315230E01
  1. Connect a hose with an inside diameter of 9 mm (0.354 in.) to the radiator drain cock as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover LH
    *a
    Hose

  1. Loosen the radiator drain cock plug.



    A338632E01
  1. Remove the radiator cap sub-assembly. Then drain the engine coolant.
    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Disconnect the hose from the radiator drain cock.



3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A337994
  1. Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

  1. Disengage the ventilation hose clamp.



    A337996
  1. Disconnect the mass air flow meter sub-assembly connector.

  1. Disengage the wire harness clamp.



    A337995
  1. Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.

  1. Disengage the 2 air cleaner cap clamps and 2 guides.



    A337997
  1. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.



4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    A337998
  1. Disconnect the throttle body with motor assembly connector.

  1. Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

    NOTICE:
    If the throttle body with motor assembly has been struck or dropped, replace it.



    A337999E01
  1. Slide the 2 clips and disconnect the No. 2 water by-pass hose and No. 3 water by-pass hose from the throttle body with motor assembly.
    Text in Illustration 
    *1
    No. 2 Water By-pass Hose
    *2
    No. 3 Water By-pass Hose



5. REMOVE THROTTLE BODY GASKET


    A338000
  1. Remove the throttle body gasket from the intake manifold.