Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket to the ECM with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket to the ECM with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



3. INSTALL ECM
  1. Install the ECM with the 3 nuts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

    NOTICE:
    If the ECM has been struck or dropped, replace it.



    A338003
  1. Engage the wire harness clamp.

  1. Connect the 2 ECM connectors and lower the 2 levers.

    NOTICE:
    1. When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
    2. Be sure to securely connect the ECM connectors.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
(Click here)