Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here


NOTICE:
  1. Perform the Vehicle Identification Number (VIN) registration when replacing the ECM (Click here).
  2. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ECM


    A338002
  1. Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

  1. Disengage the wire harness clamp.



    A338004
  1. Remove the 3 nuts and ECM.

    NOTICE:
    If the ECM has been struck or dropped, replace it.



3. REMOVE NO. 1 ECM BRACKET


    A338005
  1. Remove the 2 screws and No. 1 ECM bracket from the ECM.



4. REMOVE NO. 2 ECM BRACKET


    A338006
  1. Remove the 2 screws and No. 2 ECM bracket from the ECM.