Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No.1 Voltage and Accelerator Position Sensor No.2 Voltage.

  1. Read the values displayed on the GTS.

    Standard Voltage:

    GTS Display
    Condition
    Specified Condition
    Accelerator Position Sensor No.1 Voltage
    Accelerator pedal fully released
    0.5 to 1.1 V
    Accelerator pedal fully depressed
    2.6 to 4.5 V
    Accelerator Position Sensor No.2 Voltage
    Accelerator pedal fully released
    1.2 to 2.0 V
    Accelerator pedal fully depressed
    3.4 to 4.75 V

    If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.