Home › Engine / Hybrid System · 6AR-FSE › ENGINE CONTROL › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY


    A334357E01
  1. Perform a visual check for any foreign matter on the temperature sensor (thermistor) of the mass air flow meter sub-assembly shown in the illustration.
    Text in Illustration 
    *a
    Thermistor

    OK:
    There is no foreign matter.

    If the result is not as specified, replace the mass air flow meter sub-assembly.



    A334358E02
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Mass Air Flow Meter Sub-assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    4 (THA) - 2 (E2G)
    -20°C (-4°F)
    13.6 to 18.4 kΩ
    20°C (68°F)
    2.21 to 2.69 kΩ
    60°C (140°F)
    0.49 to 0.67 kΩ

    If the result is not as specified, replace the mass air flow meter sub-assembly.