CAMSHAFT POSITION SENSOR > INSTALLATION |
| 1. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side) |
Clean and degrease the threads of the bolt for the camshaft position sensor.
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
![]() |
Apply adhesive to 2 or 3 threads of the bolt.
| *a | Adhesive 1324 |
Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
Connect the camshaft position sensor connector.
| 2. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side) |
Clean and degrease the threads of the bolt for the camshaft position sensor.
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
![]() |
Apply adhesive to 2 or 3 threads of the bolt.
| *a | Adhesive 1324 |
Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
Connect the camshaft position sensor connector.
| 3. INSPECT FOR ENGINE OIL LEAK |
Start the engine. Make sure that there are no engine oil leaks from the area that was worked on.
| 4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Engage the 3 grommets to install the No. 1 engine cover sub-assembly.