Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)


    A338011
  1. Disconnect the camshaft position sensor connector.

  1. Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

    NOTICE:
    If the camshaft position sensor has been struck or dropped, replace it.



3. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)


    A338010
  1. Disconnect the camshaft position sensor connector.

  1. Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

    NOTICE:
    If the camshaft position sensor has been struck or dropped, replace it.