Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Clean and degrease the threads of the bolt for the crankshaft position sensor.

  1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    NOTICE:
    If reusing the crankshaft position sensor, be sure to inspect the O-ring.



    A192239E21
  1. Apply adhesive to 2 or 3 threads of the bolt.
    Text in Illustration 
    *a
    Adhesive 1324

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

  1. Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }

    NOTICE:
    1. If the crankshaft position sensor has been struck or dropped, replace it.
    2. Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.

  1. Connect the crankshaft position sensor connector.