Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE IGNITION COIL ASSEMBLY


    A338015
  1. Disconnect the 4 ignition coil assembly connectors.

  1. Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

    NOTICE:
    If an ignition coil assembly has been struck or dropped, replace it.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE SPARK PLUG


    A338016
  1. Remove the 4 spark plugs from the cylinder head sub-assembly.

    NOTICE:
    If a spark plug has been struck or dropped, replace it.

    HINT:
    Arrange the removed parts in the correct order.